Ozone Measurement / Ozone
Water Treatment : Ozone Probes
OZ1 Ozone Probe
Suitable for
Ozone
measurements and Ozone water treatment in potable water, swimming pools and water for
industrial use.
The water should not contain any surface agents.
- System: 2-electrode-system
- Response Time: t90 in less than 15 seconds
- Short run in time: Less than 30 minutes. Good long term
stability
- pH Range: 1 to 14 pH
- Slope Loss: Less than 1% per month
- Temperature Range: 0 to 45°C, temperature compensated
Chlorine is measured with the factor 0.03 of its DPD-1 value.
Chlorine Dioxide is measured with the factor 0.7 of its DPD-1 value.
OZ1.N Ozone Probe
- Range: 0.00 to 5.00 mg/l (ppm) Ozone
- Resolution: 0.01 ppm Ozone
- Slope: -100 mV per ppm Ozone
- Connection: 4 pole connector
- Power Supply: ±5 to ±15 V DC
OZ1.H Ozone Probe
High resolution version.
- Range: 0.000 to 1.000 mg/l (ppm) Ozone
- Resolution: 0.001 ppm Ozone
- Slope: -1000 mV per ppm Ozone
- Connection: 4 pole connector
- Power Supply: ±5 to ±15 V DC
OZ1.MA0.5 Ozone Probe
- Range: 0.00 to 0.5 mg/l (ppm) Ozone
- Resolution: 0.01 ppm Ozone
- Connection: 4 to 20 mA, 2 wire
- Cable Connection: Terminal strip, PG7
OZ1.MA2 Ozone Probe
- Range: 0.00 to 2.00 mg/l (ppm) Ozone
- Resolution: 0.01 ppm Ozone
- Connection: 4 to 20 mA, 2 wire
- Cable Connection: Terminal strip, PG7
OZ7 Ozone Probe
This probe is resistant to chemical and surface agents because of
its special membrane system.
Chlorine does not interfere.
- System: 2-electrode-system
- Response Time: t90 ca. 1 minute
- Temperature Range: 0 to 55°C, temperature compensated
- pH Range: 2 to 12 pH
OZ7.N Ozone Probe
- Range: 0.00 to 5.00 mg/l (ppm) Ozone
- Resolution: 0.01 ppm Ozone
- Slope: -100 mV per ppm Ozone
- Connection: 4 pole connector
- Power Supply: ±5 to ±15 V DC
OZ7.H Ozone Probe
High resolution version.
- Range: 0.000 to 0.5 mg/l (ppm) Ozone
- Resolution: 0.001 ppm Ozone
- Slope: -1000 mV per ppm Ozone
- Connection: 4 pole connector
- Power Supply: ±5 to ±15 V DC
OZ7.MA Ozone Probe
0 to 0.5 ppm, 0 to 2.0 ppm and 0 to 5.0 ppm - 4 to 20 mA, 2 wire
versions on request.
Other Ozone probe types and ranges on request.
For full details of our Water Disinfection range -
please click
here to download our catalogue.
Click Here to go to
Disinfection Probes Page
Click Here to go to Electrochemical Sensors Home Page
|