Field/Laboratory/Industrial Electrochemical Sensors
|
Chlorine :
Chlorine Probes for measuring Chlorine in Water.
CL4 Chlorine Probe
Suitable for measurement
of chlorine in water, swimming pools and water for industrial use.
No surface agents should be present.
- System: 2-electrode-system
- Short run in time: Less than 30 minutes. Good
long term stability
- Flow: ca. 30 l/hour, low flow dependency
- pH Range: 5.5 to 8 (please see dissociation
curve)
- Response Time: t90 in less than 30 seconds
- Slope Loss: Less than 1% per month
- Temperature Range: 0 to 45°C, temperature
compensated
The presence of Chlorine Dioxide and Ozone increase
the signal.
CL4.1N Chlorine Probe
- Range: 0.00 to 10.00 mg/l (ppm) Chlorine
- Resolution: 0.01 ppm Chlorine
- Slope: -100 mV per ppm Chlorine
- Connection: 4 pole connector
- Power Supply: ±5 to ±15 V DC
CL4.1H Chlorine Probe
High resolution version, preferably for potable
water.
- Range: 0.000 to 2.000 mg/l (ppm) Chlorine
- Resolution: 0.001 ppm Chlorine
- Slope: -1000 mV per ppm Chlorine
- Connection: 4 pole connector
- Power Supply: ±5 to ±15 V DC
CL4.1MA0.5 Chlorine Probe
High resolution version.
- Range: 0.000 to 0.5 mg/l (ppm) Chlorine
- Resolution: 0.001 ppm (1 µg/l) Chlorine
- Connection: 4 to 20 mA, 2 wire
- Cable Connection: Terminal strip, PG7
CL4.1MA2 Chlorine Probe
- Range: 0.00 to 2.00 mg/l (ppm) Chlorine
- Resolution: 0.01 ppm Chlorine
- Connection: 4 to 20 mA, 2 wire
- Cable Connection: Terminal strip, PG7
CL4.1MA5 Chlorine Probe
- Range: 0.00 to 5.00 mg/l (ppm) Chlorine
- Resolution: 0.01 ppm Chlorine
- Connection: 4 to 20 mA, 2 wire
- Cable Connection: Terminal strip, PG7
CL2.1N Chlorine Probe
Suitable for measurement in brine up to 30%
salinity.
- Range: 0.00 to 2.00 mg/l (ppm) Chlorine
- Resolution: 0.01 ppm Chlorine
- Slope: -100 mV per ppm Chlorine
- Connection: 4 pole connector
- Power Supply: ±5 to ±15 V DC
For full details of our Water Disinfection range -
please click
here to download our catalogue.
Click Here to go to Electrochemical Sensors Home Page |